The B&W Rubber Cover for Empty Turnoverball Socket, # BWGNXA1715, is made specifically for use with B&W for socket in truck beds that do not allow you to store your Turnoverball in place. This will not compress. view full answer...
It is possible for your 2021 Grand Design Reflection 303RLS to go from 16 inch to 17-1/2 inch wheels and tires, yes. You currently have a hub with a 6 on 5-1/2" bolt pattern, and since you mentioned replacing the suspension you would need one that had a hub with an 8 on 6-1/2" bolt pattern.
Your Grand Design currently has ST235/80R16 size tires, and if you went with 17-1/2 inch wheels the overall tire size would actually decrease slightly if you went to 215/75R17.5 tires (from 30.9" diameter/9.4"... view full answer...
Please note the attached image of the Bauer Products RV Baggage Door Slam Latch, # BA57FR. If you think you may have ordered the incorrect item, please forward an image of what you have and measurements. This part is specifically made to replace the Bauer BP-20. view full answer...
The best option that we have, that will allow you to record the cameras is the Rear View Safety Wireless Backup Camera System # RVS-4CAM. This system has a 7" quad view display and built in DVR that accepts SD cards up to 128 GB for storing the recordings.
The Rear View Safety Wireless Backup Camera System # RVS-4CAM comes with 1 camera, but can support up to 4 cameras. Additional cameras can be added using the Rear View Safety 130-Degree Wireless Backup Camera # RVS-DS1. There are not... view full answer...
The rear external sensor of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 can be found either in line with the rear jacks or just a few feet behind them, directly in the center of the trailer. Most likely your Reflection has some corrugated plastic covering the underbelly so you'll have to cut it open to get a better look. I usually cut a flap open so that I can stitch it back together with zip-ties to prevent any unwanted pest from getting in. view full answer...
Yes, the Furrion Chill HE RV Air Conditioner System # FR23PV comes with the Premium Wall Thermostat # FR33PR which has a temperature sensor wire (pictured below) to sense the temperature instead of the previous versions that had the sensor built into the controller up in the air distribution box. view full answer...
The MaxxAir part number for the vent # MA26JR is 00-933083. If you have a different model in mind, feel free to respond to this answer with the part you are looking for. view full answer...
Unfortunately, we do not have a video specific to your GD310GK for the LED Marker Light RV Side Cameras w/ Night Vision for Furrion Vision S Systems # FCE48TASL.
I went ahead and linked two videos of two different 5th wheels. Hopefully, the information in those video can help you with your GD310GK. view full answer...
This is great information! Thank you for reaching out to us with this tip. You're correct that the rain sensor closes the MaxxFan's cover when it detects surrounding rain or snow.
As noted in our product description for the # MA00-04500K, there's also a button on your MaxxFan's keypad that allows you to deactivate the sensor in situations like this, but tread carefully. These safety lockouts are designed to prevent excess moisture from entering your Grand Design Reflection 320MKS from... view full answer...
The monitor included with the Furrion # FCE48TASL-05 Vision S camera system can display a quad split screen or a single image. The term 'adequate' is pretty subjective, what one person would find adequate, another possibly wouldn't.
The primary use of the camera system while the RV is under way is to provide the driver with a view of what's behind the RV (and alongside with the 3 camera system). In my opinion, in the quad screen mode, the average person will be able to see more than enough... view full answer...
The Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System # LC344792 actually comes from the manufacturer with the motor already installed so there is not an option to purchase it separately.
With that being said you could still use your old motor if you'd like, and keep the one that comes with it as a spare. view full answer...
In regards to the Lippert AP Kit part # LC52SV, the wet bolts are pressed into the shackle so you can't purchase them separately. That said, I recommend going with the MORryde Suspension Upgrade Kit for Tandem Axle Trailers part # MR76ZR instead as it's less expensive and comes with more. It has wet bolts, heavy duty shackle straps, and bronze bushings. The wet bolts are needed to keep the bushings lubricated properly so they last a long time. view full answer...
To replace your Shelby 5480A 2-speed winch with one that can be used in the manner you specified, it sounds like you need one with a handbrake. Since you also require one with cable and at least 3,200 lbs, the closest option is the Fulton High-Performance 2-Speed Trailer Winch with Handbrake - Cable Only - Zinc - 3,700 lbs # F142430. view full answer...
There are no backup cameras for your Grand Design Reflection that integrate with the Ford backup camera, so while I realize it's not the answer you were looking for, you will need to get a separate monitor. The good news about that is you have your choice of size of monitor so you can go with a smaller one if you want to take up less space, or a larger one for the best view possible.
Here are the options for Furrion systems for your pre-wired Grand Design Reflection:
- 4.3" Screen: Furrion... view full answer...
While we do not have a video showing the installation of the line relocation kit that comes with the SumoSprings Trailer Helper Springs # TSS-107-40, I have linked a video below that shows an example of when one will be needed and explains what the kit does. It is brought up at the 3:50 time in the video linked below. view full answer...
If you purchase it from us, the Progressive Dynamics # PD9280A Power Converter/Charger does indeed have a 14 digit serial number that begins with the letter 'A'. The carries the full 2 year manufacturer's warranty. This has been confirmed with my contact at Progressive Dynamics.
If you click the provided link, you can see a product description video showing my buddy Jeff explain the features of the converter/charger. view full answer...
The LED Strip Light # ILL70CB is intended to be an interior light, and while the light is technically weatherproof, it is not recommended to use in a location that is directly exposed to the elements. A very similar light is the Optronics Thinline LED # UCL59CB. This is designed as an exterior utility light, and would work great on the front cap of your 5th wheel. The light itself is 12-3/8" long, with mounting holes 11-3/4" apart. I am afraid we do not have any exterior light strips with... view full answer...
We do have 1/2"-20 lug nuts that are solid and not capped, though no OEM direct replacements. What you can use is the following:
- DeeMaxx Trailer Wheel Lug Nut # DE93GR view full answer...